| This article will give you important instructions and | | | | shortly for installing the shut off valves. |
| precautions that has to be maintained while installing. | | | | - You should align properly the tubes into fittings.The |
| This also includes the installation procedures for | | | | various items required are pipes for hot supply lines, |
| connecting the tub into the present drainage system. | | | | cold supply lines and a pipe which leads to a shower |
| Once you rough in the items, you should assemble | | | | head. The shower head, air chamber and mixing valve |
| the shower and bath tub. | | | | is also required. |
| Some Mistakes that are to be avoided while fitting: | | | | The floor area required for installing a shower is stall |
| - You should not ignore any local codes that has to | | | | should be minimum 1024 square inches. Also allow 24 |
| be used. | | | | inches from the stall. The bath tub and shower will |
| - You should not use pipes that are very small. | | | | require supports for holding it firmly. Also the bath |
| - You should not attach copper to galvanized without | | | | tub when it is filled with water makes the bath tub |
| an brass or dielectric fitting between. | | | | very heavy. Before installing, please check the building |
| - At threaded joining, you should not use PTFE Tape | | | | codes and the frame support that are required for |
| - You should level the fixtures when installing. | | | | installing the bath tub. You should install all the pipes |
| - You should install a air gap filling for fixing. | | | | before installing the tub. |
| - You should not cut the supply stub outs very | | | | |