| Some people find it quite hard to hang a door here | | | | the bottom if you Require 3 hinges mark the center |
| are some easy Steps to getting your marking out | | | | of the door. Now place your hinges on the marked |
| and clearance gaps right with ease. First place your | | | | lines and mark top and bottom of The hinge this will |
| door in the frame (some doors may need plaining | | | | give you an accurate mark for the cutting out of |
| first For they to fit into the old frame). | | | | The hinge. |
| Once the door fits into the frame make sure you | | | | Now draw round the hinge on the door and the |
| have a 6mm gap down One side to allow for a | | | | frame and cut out the Depth of the hinge on the |
| correct gap once hung. Now wedge the bottom of | | | | door and frame. Now screw the hinges onto the |
| the door up to the head of the frame putting a 3mm | | | | door , then lift the door to the frame And screw the |
| packer between the top of the door and frame (for | | | | hinge to the frame side. |
| a 3mm clearance) Now wedge one side of the door | | | | Now you should have a perfect hung door with 3mm |
| tight to the side of the frame (hanging Side). | | | | clearance all the way Around the door. |
| Now mark 7in from the top of the door and 9in from | | | | |